PRODUCT GUIDE

The artwork and the guard do different jobs.

Before choosing a design, it helps to be clear about what you already have on your wheelchair and what you are requesting.

YOUR DESIGN. READY FOR YOUR WHEELS.

What arrives at your door?

Already have spoke guards? Choose stickers only. Need the guards too? They arrive with your stickers already fitted.

Two blank black wheelchair spoke guards, showing their centre openings and small pre-drilled fixing holes. — Black spoke guards, before your artwork is fitted.

Meet the spoke guard

A spoke guard is the plastic panel that sits over the wheel’s spokes, helping reduce the chance of fingers getting caught. Our black guards are gently domed, with a centre opening and pre-drilled fixing holes. Clear cable ties fasten the guard to the spokes.

Your sticker adds the personality and goes onto the plastic guard — never directly onto the spokes.

For your own spoke guards

Stickers only

Two matching stickers for you to apply to your existing guards.
Rolled for delivery in a postal tube.
Clear cable ties included, in case you need replacements.
Printed fitting instructions included.

Spoke guards are not included.

Stickers arrive already fitted

Stickers + guards

Two black spoke guards with your stickers already fitted.
Sent together in a flat box.
Pre-drilled fixing holes and clear cable ties included — ready to fasten to your wheel spokes.
Printed fitting instructions included.

No sticker fitting to do yourself.

Illustrations based on our packaging. Wheelchair not included.

Why is there a slit in the sticker?

It’s a fitting cut, made on purpose. Our guards curve gently outwards rather than lying flat. A cut from the centre opening to the outer edge lets the vinyl overlap by around 5 mm, helping it sit smoothly over that shape.

We position the cut to avoid names and lettering. The illustration shows an example position; the cut and overlap may be visible on the finished sticker.

A gently domed guard, seen from the side.

Printed fitting instructions included with your order.

Fitting your stickers & spoke guards

Stickers only? Here’s how to fit them.

Use a clean spray bottle filled with water and a couple of drops of washing-up liquid.

Download fitting leaflet (PDF)

Mist the guard
Lightly spray the surface of your plastic spoke guard.
Peel & mist
Leave the rectangular backing sheet flat. Peel up one of the two stickers, then lightly spray its grey adhesive side.
Position your design
Place the sticker onto the guard and slide it into position.
Smooth it down
Smooth the sticker with a clean towel to remove excess water.

Ordered stickers + guards? We do these steps for you before posting.

Fasten the guards to your wheels

Our guards have three pairs of small, closely spaced holes. Starting behind the guard, feed a supplied clear tie through one hole and back through its neighbour. Fasten it around the nearest spoke at the back. Repeat for all three pairs.